GENWiki

Premier IT Outsourcing and Support Services within the UK

User Tools

Site Tools


rfc:rfc7238

Internet Engineering Task Force (IETF) J. Reschke Request for Comments: 7238 greenbytes Category: Experimental June 2014 ISSN: 2070-1721

The Hypertext Transfer Protocol Status Code 308 (Permanent Redirect)

Abstract

 This document specifies the additional Hypertext Transfer Protocol
 (HTTP) status code 308 (Permanent Redirect).

Status of This Memo

 This document is not an Internet Standards Track specification; it is
 published for examination, experimental implementation, and
 evaluation.
 This document defines an Experimental Protocol for the Internet
 community.  This document is a product of the Internet Engineering
 Task Force (IETF).  It represents the consensus of the IETF
 community.  It has received public review and has been approved for
 publication by the Internet Engineering Steering Group (IESG).  Not
 all documents approved by the IESG are a candidate for any level of
 Internet Standard; see Section 2 of RFC 5741.
 Information about the current status of this document, any errata,
 and how to provide feedback on it may be obtained at
 http://www.rfc-editor.org/info/rfc7238.

Copyright Notice

 Copyright (c) 2014 IETF Trust and the persons identified as the
 document authors.  All rights reserved.
 This document is subject to BCP 78 and the IETF Trust's Legal
 Provisions Relating to IETF Documents
 (http://trustee.ietf.org/license-info) in effect on the date of
 publication of this document.  Please review these documents
 carefully, as they describe your rights and restrictions with respect
 to this document.  Code Components extracted from this document must
 include Simplified BSD License text as described in Section 4.e of
 the Trust Legal Provisions and are provided without warranty as
 described in the Simplified BSD License.

Reschke Experimental [Page 1] RFC 7238 HTTP Status Code 308 June 2014

Table of Contents

 1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . 2
 2.  Notational Conventions  . . . . . . . . . . . . . . . . . . . . 2
 3.  308 Permanent Redirect  . . . . . . . . . . . . . . . . . . . . 2
 4.  Deployment Considerations . . . . . . . . . . . . . . . . . . . 3
 5.  Security Considerations . . . . . . . . . . . . . . . . . . . . 4
 6.  IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 4
 7.  Acknowledgements  . . . . . . . . . . . . . . . . . . . . . . . 5
 8.  References  . . . . . . . . . . . . . . . . . . . . . . . . . . 5
   8.1.  Normative References  . . . . . . . . . . . . . . . . . . . 5
   8.2.  Informative References  . . . . . . . . . . . . . . . . . . 5

1. Introduction

 HTTP defines a set of status codes for the purpose of redirecting a
 request to a different URI ([RFC3986]).  The history of these status
 codes is summarized in Section 6.4 of [RFC7231], which also
 classifies the existing status codes into four categories.
 The first of these categories contains the status codes 301 (Moved
 Permanently), 302 (Found), and 307 (Temporary Redirect), which can be
 classified as below:
 +-------------------------------------------+-----------+-----------+
 |                                           | Permanent | Temporary |
 +-------------------------------------------+-----------+-----------+
 | Allows changing the request method from   | 301       | 302       |
 | POST to GET                               |           |           |
 | Does not allow changing the request       | -         | 307       |
 | method from POST to GET                   |           |           |
 +-------------------------------------------+-----------+-----------+
 Section 6.4.7 of [RFC7231] states that HTTP does not define a
 permanent variant of status code 307; this specification adds the
 status code 308, defining this missing variant (Section 3).

2. Notational Conventions

 The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
 "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
 document are to be interpreted as described in [RFC2119].

3. 308 Permanent Redirect

 The 308 (Permanent Redirect) status code indicates that the target
 resource has been assigned a new permanent URI and any future
 references to this resource ought to use one of the enclosed URIs.

Reschke Experimental [Page 2] RFC 7238 HTTP Status Code 308 June 2014

 Clients with link editing capabilities ought to automatically re-link
 references to the effective request URI (Section 5.5 of [RFC7230]) to
 one or more of the new references sent by the server, where possible.
 The server SHOULD generate a Location header field ([RFC7231],
 Section 7.1.2) in the response containing a preferred URI reference
 for the new permanent URI.  The user agent MAY use the Location field
 value for automatic redirection.  The server's response payload
 usually contains a short hypertext note with a hyperlink to the new
 URI(s).
 A 308 response is cacheable by default; i.e., unless otherwise
 indicated by the method definition or explicit cache controls (see
 [RFC7234], Section 4.2.2).
    Note: This status code is similar to 301 (Moved Permanently)
    ([RFC7231], Section 6.4.2), except that it does not allow changing
    the request method from POST to GET.

4. Deployment Considerations

 Section 6 of [RFC7231] requires recipients to treat unknown 3xx
 status codes the same way as status code 300 Multiple Choices
 ([RFC7231], Section 6.4.1).  Thus, servers will not be able to rely
 on automatic redirection happening similar to status codes 301, 302,
 or 307.
 Therefore, initial use of status code 308 will be restricted to cases
 where the server has sufficient confidence in the client's
 understanding the new code or when a fallback to the semantics of
 status code 300 is not problematic.  Server implementers are advised
 not to vary the status code based on characteristics of the request,
 such as the User-Agent header field ("User-Agent Sniffing") -- doing
 so usually results in code that is both hard to maintain and hard to
 debug and would also require special attention to caching (i.e.,
 setting a "Vary" response header field, as defined in Section 7.1.4
 of [RFC7231]).
 Note that many existing HTML-based user agents will emulate a refresh
 when encountering an HTML <meta> refresh directive ([HTML]).  This
 can be used as another fallback.  For example:
 Client request:
   GET / HTTP/1.1
   Host: example.com

Reschke Experimental [Page 3] RFC 7238 HTTP Status Code 308 June 2014

 Server response:
   HTTP/1.1 308 Permanent Redirect
   Content-Type: text/html; charset=UTF-8
   Location: http://example.com/new
   Content-Length: 454
   <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01//EN"
                         "http://www.w3.org/TR/html4/strict.dtd">
   <html>
      <head>
         <title>Permanent Redirect</title>
         <meta http-equiv="refresh"
               content="0; url=http://example.com/new">
      </head>
      <body>
         <p>
            The document has been moved to
            <a href="http://example.com/new"
            >http://example.com/new</a>.
         </p>
      </body>
   </html>

5. Security Considerations

 All security considerations that apply to HTTP redirects apply to the
 308 status code as well (see Section 9 of [RFC7231]).

6. IANA Considerations

 The registration below has been added to the "Hypertext Transfer
 Protocol (HTTP) Status Code Registry" (defined in Section 8.2 of
 [RFC7231] and located at
 <http://www.iana.org/assignments/http-status-codes>):
 +-------+--------------------+---------------------------------+
 | Value | Description        | Reference                       |
 +-------+--------------------+---------------------------------+
 | 308   | Permanent Redirect | Section 3 of this specification |
 +-------+--------------------+---------------------------------+

Reschke Experimental [Page 4] RFC 7238 HTTP Status Code 308 June 2014

7. Acknowledgements

 The definition for the new status code 308 reuses text from the
 HTTP/1.1 definitions of status codes 301 and 307.
 Furthermore, thanks to Ben Campbell, Cyrus Daboo, Eran Hammer-Lahav,
 Bjoern Hoehrmann, Subramanian Moonesamy, Peter Saint-Andre, and
 Robert Sparks for feedback on this document.

8. References

8.1. Normative References

 [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
            Requirement Levels", BCP 14, RFC 2119, March 1997.
 [RFC3986]  Berners-Lee, T., Fielding, R., and L. Masinter, "Uniform
            Resource Identifier (URI): Generic Syntax", STD 66,
            RFC 3986, January 2005.
 [RFC7230]  Fielding, R., Ed. and J. Reschke, Ed., "Hypertext Transfer
            Protocol (HTTP/1.1): Message Syntax and Routing",
            RFC 7230, June 2014.
 [RFC7231]  Fielding, R., Ed. and J. Reschke, Ed., "Hypertext Transfer
            Protocol (HTTP/1.1): Semantics and Content", RFC 7231,
            June 2014.
 [RFC7234]  Fielding, R., Ed., Nottingham, M., Ed., and J. Reschke,
            Ed., "Hypertext Transfer Protocol (HTTP/1.1): Caching",
            RFC 7234, June 2014.

8.2. Informative References

 [HTML]     Raggett, D., Le Hors, A., and I. Jacobs, "HTML 4.01
            Specification", W3C Recommendation REC-html401-19991224,
            December 1999,
            <http://www.w3.org/TR/1999/REC-html401-19991224>.
            Latest version available at
            <http://www.w3.org/TR/html401>.

Reschke Experimental [Page 5] RFC 7238 HTTP Status Code 308 June 2014

Author's Address

 Julian F. Reschke
 greenbytes GmbH
 Hafenweg 16
 Muenster, NW  48155
 Germany
 EMail: julian.reschke@greenbytes.de
 URI:   http://greenbytes.de/tech/webdav/

Reschke Experimental [Page 6]

/home/gen.uk/domains/wiki.gen.uk/public_html/data/pages/rfc/rfc7238.txt · Last modified: 2014/06/07 00:59 by 127.0.0.1

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki