GENWiki

Premier IT Outsourcing and Support Services within the UK

User Tools

Site Tools


rfc:rfc5453

Network Working Group S. Krishnan Request for Comments: 5453 Ericsson Category: Standards Track February 2009

                Reserved IPv6 Interface Identifiers

Status of This Memo

 This document specifies an Internet standards track protocol for the
 Internet community, and requests discussion and suggestions for
 improvements.  Please refer to the current edition of the "Internet
 Official Protocol Standards" (STD 1) for the standardization state
 and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

 Copyright (c) 2009 IETF Trust and the persons identified as the
 document authors.  All rights reserved.
 This document is subject to BCP 78 and the IETF Trust's Legal
 Provisions Relating to IETF Documents (http://trustee.ietf.org/
 license-info) in effect on the date of publication of this document.
 Please review these documents carefully, as they describe your rights
 and restrictions with respect to this document.

Abstract

 Interface identifiers in IPv6 unicast addresses are used to identify
 interfaces on a link.  They are required to be unique within a
 subnet.  Several RFCs have specified interface identifiers or
 identifier ranges that have a special meaning attached to them.  An
 IPv6 node autoconfiguring an interface identifier in these ranges
 will encounter unexpected consequences.  Since there is no
 centralized repository for such reserved identifiers, this document
 aims to create one.

Krishnan Standards Track [Page 1] RFC 5453 Reserved IPv6 Interface Identifiers February 2009

Table of Contents

 1. Introduction ....................................................2
    1.1. Applicability ..............................................2
    1.2. Requirements Notation ......................................3
 2. Issues with Reusing Reserved Interface Identifiers ..............3
    2.1. Possible Solutions .........................................3
 3. IANA Considerations .............................................3
 4. Acknowledgements ................................................4
 5. Security Considerations .........................................4
 6. References ......................................................5
    6.1. Normative References .......................................5
    6.2. Informative References .....................................5
 Appendix A. List of Potentially Affected RFCs ......................6

1. Introduction

 An IPv6 unicast address is composed of two parts: a subnet prefix and
 an interface identifier (IID) that identifies a unique interface
 within the subnet prefix.  The structure of an IPv6 unicast address
 is depicted in "IPv6 Addressing Architecture" [RFC4291] and is
 replicated here for clarity.
 |          n bits               |           128-n bits            |
 +-------------------------------+---------------------------------+
 |       subnet prefix           |           interface ID          |
 +-------------------------------+---------------------------------+
                 Figure 1: IPv6 Unicast Address Format
 For all unicast addresses, except those that start with the binary
 value 000, Interface IDs are required to be 64 bits long and to be
 constructed in Modified EUI-64 format [RFC4291].  Examples of
 mechanisms that generate interface identifiers without a unique token
 include Cryptographically Generated Addresses [RFC3972], Privacy
 Addresses [RFC4941], Hash-Based Addresses [HBA], etc.  Non-unique
 interface identifiers can also be allocated using managed address
 assignment mechanisms like DHCPv6 (Dynamic Host Configuration
 Protocol for IPv6) [RFC3315].

1.1. Applicability

 This document applies only to interface identifiers that are formed
 in the modified EUI-64 format as defined in Appendix A of [RFC4291].
 All other types of interface identifiers are out of its scope.

Krishnan Standards Track [Page 2] RFC 5453 Reserved IPv6 Interface Identifiers February 2009

1.2. Requirements Notation

 The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
 "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
 document are to be interpreted as described in [RFC2119].

2. Issues with Reusing Reserved Interface Identifiers

 Let us assume a node comes up with an interface identifier that has
 been reserved for use in some other capacity, e.g., an IPv6 node that
 uses temporary IPv6 addresses [RFC4941] comes up with an IID of
 fdff:ffff:ffff:ffff.  This node will receive requests from all nodes
 that are requesting a service from a Mobile IPv6 home agent since the
 above-mentioned interface identifier has been reserved in [RFC2526]
 to serve as a MIPv6 home agent's anycast address.  At best, this is
 an annoyance to the node that came up with this address.  At worst,
 another node on the link would be denied service and may not look for
 other methods of acquiring a home agent.  Thus, such reserved
 interface identifiers MUST NOT be used for autonomous
 autoconfiguration or for managed address configuration.

2.1. Possible Solutions

 There are two possible ways to go about avoiding usage of these
 reserved interface identifiers.  One of them would be to add a
 normative reference to each specification that reserves an interface
 identifier.  The other would be to create an IANA registry for such
 interface identifiers.  There are two disadvantages to the normative
 reference approach.  Firstly, this approach does not scale well
 because the number of such specifications that would need to be
 updated is large.  Secondly, the maturity level of the document
 reserving the IID might be lower than the one prohibited from using
 it; this will cause a downward reference problem.  Therefore, the
 better solution is to create an IANA registry for this purpose.

3. IANA Considerations

 This document creates an IANA registry for reserved IPv6 interface
 identifiers.  Initial values for the reserved IPv6 interface
 identifiers are given below.

Krishnan Standards Track [Page 3] RFC 5453 Reserved IPv6 Interface Identifiers February 2009

 +-----------------------------------------+-------------------------+
 |        Interface Identifier Range       |       Description       |
 +-----------------------------------------+-------------------------+
 |           0000:0000:0000:0000           |  Subnet-Router Anycast  |
 |                                         |        [RFC4291]        |
 |                                         |                         |
 | FDFF:FFFF:FFFF:FF80-FDFF:FFFF:FFFF:FFFF | Reserved Subnet Anycast |
 |                                         |    Addresses[RFC2526]   |
 +-----------------------------------------+-------------------------+
                     Table 1: Current Assignments
 It is possible that implementations might predate a specific
 assignment from this registry and hence not be cognizant of the
 reserved nature of the interface identifier.  Hence, future
 assignments from this registry are discouraged.  Future assignments,
 if any, are to be made through Standards Action [RFC5226].
 Assignments consist of a single interface identifier or a range of
 interface identifiers.
 NOTE: The address :: (all zeros in the interface identifier field) is
 used as the unspecified address and ::/0 is used as a default route
 indicator, as specified in [RFC5156].  These uses do not conflict
 with the reserved interface identifiers defined here, since the
 reserved identifiers defined in this document are used for avoiding
 conflicts with stateless address autoconfiguration that utilizes a
 64-bit prefix length.

4. Acknowledgements

 The author would like to thank Alain Durand, Alex Petrescu, Bernie
 Volz, Bob Hinden, Christian Huitema, Fred Templin, Jordi Palet
 Martinez, Pekka Savola, Remi Denis-Courmount, Tim Enos, Ed
 Jankiewicz, Brian Carpenter, Alfred Hoenes, Jari Arkko, Pasi Eronen,
 Tim Polk, Lars Eggert, Derek Atkins, and Robert Sparks for reviewing
 this document and suggesting changes.

5. Security Considerations

 By utilizing one of the reserved interface identifiers, an IPv6 node
 might receive requests that it is not authorized to receive.
 Information that creates or updates a registration in this registry
 needs to be authenticated and authorized by the IANA based on the
 instructions set forth by [RFC5226].

Krishnan Standards Track [Page 4] RFC 5453 Reserved IPv6 Interface Identifiers February 2009

6. References

6.1. Normative References

 [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
            Requirement Levels", BCP 14, RFC 2119, March 1997.
 [RFC2526]  Johnson, D. and S. Deering, "Reserved IPv6 Subnet Anycast
            Addresses", RFC 2526, March 1999.
 [RFC4291]  Hinden, R. and S. Deering, "IP Version 6 Addressing
            Architecture", RFC 4291, February 2006.
 [RFC5226]  Narten, T. and H. Alvestrand, "Guidelines for Writing an
            IANA Considerations Section in RFCs", BCP 26, RFC 5226,
            May 2008.

6.2. Informative References

 [HBA]      Bagnulo, M., "Hash Based Addresses (HBA)", Work in
            Progress, October 2006.
 [RFC3315]  Droms, R., Ed., Bound, J., Volz, B., Lemon, T., Perkins,
            C., and M. Carney, "Dynamic Host Configuration Protocol
            for IPv6 (DHCPv6)", RFC 3315, July 2003.
 [RFC3972]  Aura, T., "Cryptographically Generated Addresses (CGA)",
            RFC 3972, March 2005.
 [RFC4941]  Narten, T., Draves, R., and S. Krishnan, "Privacy
            Extensions for Stateless Address Autoconfiguration in
            IPv6", RFC 4941, September 2007.
 [RFC5156]  Blanchet, M., "Special-Use IPv6 Addresses", RFC 5156,
            April 2008.

Krishnan Standards Track [Page 5] RFC 5453 Reserved IPv6 Interface Identifiers February 2009

Appendix A. List of Potentially Affected RFCs

 Implementations of the following RFCs need to be aware of the
 reserved interface identifier ranges when they allocate new
 addresses.  Future revisions of these RFCs should ensure that this is
 either already sufficiently clear or that the text is amended to take
 this into account.
 o  RFC 2590 - Transmission of IPv6 Packets over Frame Relay Networks
    Specification
 o  RFC 3315 - Dynamic Host Configuration Protocol for IPv6 (DHCPv6)
 o  RFC 3972 - Cryptographically Generated Addresses (CGA)
 o  RFC 4489 - A Method for Generating Link-Scoped IPv6 Multicast
    Addresses
 o  RFC 4862 - IPv6 Stateless Address Autoconfiguration
 o  RFC 4941 - Privacy Extensions for Stateless Address
    Autoconfiguration in IPv6
 o  RFC 4982 - Support for Multiple Hash Algorithms in
    Cryptographically Generated Addresses (CGAs)
 o  RFC 5072 - IP Version 6 over PPP

Author's Address

 Suresh Krishnan
 Ericsson
 8400 Decarie Blvd.
 Town of Mount Royal, QC
 Canada
 Phone: +1 514 345 7900 x42871
 EMail: suresh.krishnan@ericsson.com

Krishnan Standards Track [Page 6]

/home/gen.uk/domains/wiki.gen.uk/public_html/data/pages/rfc/rfc5453.txt · Last modified: 2009/02/10 18:43 by 127.0.0.1

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki