Network Working Group K. Sarcar Request for Comments: 3827 Sun Microsystems, Inc. Category: Informational June 2004
Additional Snoop Datalink Types
Status of this Memo
This memo provides information for the Internet community. It does not specify an Internet standard of any kind. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2004).
Abstract
The snoop file format provides a way to store and exchange datalink layer packet traces. This document describes extensions to this file format to support new media.
1. Introduction
[RFC1761] defines the snoop file format used to store captured network packets for tools that capture, display, and interpret network traffic. The file format specifies a header containing the Datalink Type field that identifies the network's datalink type. This document defines new values for this field, as well as an IANA registry for future datalink types.
2. New Datalink Types
In addition to the Datalink Type codes listed in [RFC1761], this document defines the following type codes for the corresponding media:
Datalink Type Code
------------- ----
Fibre Channel 16
ATM 17
ATM Classical IP 18
IP over Infiniband 26
The IP over Infiniband packet format is described in [IPoIB].
Sarcar Informational [Page 1] RFC 3827 Additional Snoop Datalink Types June 2004
3. IANA Considerations
This document created a new IANA registry named "Snoop Datalink Types" to hold the various possible 32-bit (4 octet) snoop datalink types. This new registry holds the values previously defined in [RFC1761] and tabulated below:
Datalink Type Code
------------- ----
IEEE 802.3 0
IEEE 802.4 Token Bus 1
IEEE 802.5 Token Ring 2
IEEE 802.6 Metro Net 3
Ethernet 4
HDLC 5
Character Synchronous 6
IBM Channel-to-Channel 7
FDDI 8
Other 9
Additionally, the new registry also holds the values defined above in section 2 of this document.
All new allocations and assignments to this registry starting from code 27 will follow the First Come First Served policy outlined in [BCP0026]. Type codes up to 26 not defined by this section of the document (10-15 and 19-25) are considered reserved.
4. Security Considerations
The addition of new datalink type codes to the existing file format poses no known security risks.
5. Acknowledgements
The author would like to thank Jim Carlson, Brent Callaghan, and Bill Strahm for meticulously reviewing this document.
6. References
6.1. Normative References
[RFC1761] Callaghan, B. and R. Gilligan, "Snoop Version 2 Packet
Capture File Format", RFC 1761, February 1995.
Sarcar Informational [Page 2] RFC 3827 Additional Snoop Datalink Types June 2004
[BCP0026] Narten, T. and H. Alvestrand, "Guidelines for Writing an
IANA Considerations Section in RFCs", BCP 26, RFC 2434,
October 1998.
6.2. Informative References
[IPoIB] Kashyap, V. and H.K. Chu, "IP encapsulation and address
resolution over InfiniBand networks", Work in Progress,
April 2003.
7. Author's Address
Kanoj Sarcar Sun Microsystems, Inc. 14 Network Circle Bldg 14, MPK14-333 Menlo Park, CA 94025
Phone: 1-650-786-4785 EMail: kanoj.sarcar@sun.com
Sarcar Informational [Page 3] RFC 3827 Additional Snoop Datalink Types June 2004
8. Full Copyright Statement
Copyright (C) The Internet Society (2004). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights.
This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the Internet Society.
Sarcar Informational [Page 4]