GENWiki

Premier IT Outsourcing and Support Services within the UK

User Tools

Site Tools


rfc:rfc1879

Network Working Group B. Manning, Editor Request for Comments: 1879 ISI Category: Informational January 1996

                     Class A Subnet Experiment
                    Results and Recommendations

Status of this Memo

 This memo provides information for the Internet community.  This memo
 does not specify an Internet standard of any kind.  Distribution of
 this memo is unlimited.

Discussion/Purpose

 This memo documents some experiences with the RFC 1797 [1] subnet A
 experiment (performed by the Net39 Test Group (see credits)) and
 provides a number of recommendations on future direction for both the
 Internet Registries and the Operations community.
 Not all proposed experiments in RFC 1797 were done. Only the "case
 one" type delegations were made.  Additional experimentation was done
 within the DNS service, by supporting a root nameserver and the
 primary for the domain from within the subnetted address space.  In
 addition, testing was done on classless delegation [2].
 Internet Services offered over the RFC 1797 experiment were:
       Finger
       HTTP
       Telnet
       FTP server/client
       Gopher
       kerberos
       lpr (and its ilk)
       X
       DNS
 F.Root-Servers.Net, a root name server had an interface defined as
 part of the RFC 1797 experiment.  Attached is a report fragment on
 it's performance: "My root server has processed 400,000,000 queries
 in the last 38 days, and well over half of them were to the temporary
 39.13.229.241 address (note that I retained the old 192.5.5.241
 address since I knew a lot of folks would not update their root.cache
 files and I didn't want to create a black hole.)" - Paul Vixie

Manning Informational [Page 1] RFC 1879 Class A Subnet Experiment January 1996

 Initial predictions [3] seemed to indicate that the safest path for
 an ISP that participates in such a routing system is to have -all- of
 the ISP clients be either:
              a) singly connected to one upstream ISP
      OR
              b) running a classless interior routing protocol
 It is also noted that a network with default route may not notice it
 has potential routing problems until it starts using subnets of
 traditional A's internally.

Problems & Solutions

Operations

 There were initial problems in at least one RIPE181 [4]
 implementation.  It is clear that operators need to register in the
 Internet Routing Registry (IRR) all active aggregates and delegations
 for any given prefix.  Additionally, there need to be methods for
 determining who is authoritative for announcing any given prefix.
 It is expected that problems identified within the confines of this
 experiment are applicable to some RFC 1597 prefixes or any "natural"
 class "A" space.
 Use of traceroute (LSRR) was critical for network troubleshooting
 during this experiment. In current cisco IOS, coding the following
 statement will disable LSRR and therefore inhibit cross-provider
 troubleshooting:
              no ip source-route
 We recommend that this statement -NOT- be placed in active ISP cisco
 configurations.
 In general, there are serious weaknesses in the Inter-Provider
 cooperation model and resolution of these problems is outside the
 scope of this document. Perhaps the IEPG or any/all of the national
 or continental operations bodies [5] will take this as an action item
 for the continued health and viability of the Internet.

Manning Informational [Page 2] RFC 1879 Class A Subnet Experiment January 1996

Routing

 A classic cisco configuration that has the following statements
              ip route 39.1.28.0 255.255.255.0
              router bgp 64000
              redistribute static
 will, by default, promote any classful subnet route to a full
 classful route (supernet routes will be left alone).  This behaviour
 can be changed in at least the following two ways:
      1:
              ip route 39.1.28.0 255.255.255.0
              router bgp 64000
              no auto-summary
              redistribute static
      2:
              ip route 39.1.28.0 255.255.255.0
              router bgp 64000
              network 39.1.28.0 mask 255.255.255.0
              redistribute static route-map static-bgp
              ....
              access-list 98 deny 39.1.28.0 0.255.255.255
              access-list 98 permit any
              ....
              route-map static-bgp
              match ip address 98
 Users of cisco gear currently need to code the following two
 statements:
              ip classless
              ip subnet-zero
 The implication of the first directive is that it eliminates the idea
 that if you know how to talk to a subnet of a network, you know how
 to talk to ALL of the network.
 The second is needed since it is no longer clear where the all-ones
 or all-zeros networks are [6].
 Other infrastructure gear exhibited similar or worse behaviour.
 Equipment that depends on use of a classful routing protocol, such a
 RIPv1 are prone to misconfiguration.  Tested examples are current
 Ascend and Livingston gear, which continue to use RIPv1 as the
 default/only routing protocol.  RIPv1 use will create an aggregate

Manning Informational [Page 3] RFC 1879 Class A Subnet Experiment January 1996

 announcement.
 This pernicious use of this classful IGP was shown to impact
 otherwise capable systems.  When attempting to communicate between an
 Ascend and a cisco the promotion problem identified above, was
 manifest. The problem turned out to be that a classful IGP (RIPv1)
 was being used between the Ascends and ciscos. The Ascend was told to
 announce 39.1.28/24, but since RIPv1 can't do this, the Ascend
 instead sent 39/8.  We note that RIPv1, as with all classful IGPs
 should be considered historic.
 This validates the predictions discussed in [3].

Cisco Specific Examples

 There are actually three ways to solve the unintended aggregation
 problem, as described with current cisco IOS.  Which of them applies
 will depend on what software version is in the router. Workarounds
 can be implemented for ancient (e.g., 8.X) version software.
      o Preferred solution: turn on "ip classless" in the
        routers and use a default route inside the AS.
        The "ip classless" command prevents the existence of
        a single "subnet" route from blocking access via the
        default route to other subnets of the same old-style network.
        Default only works with single-homed ISPs.
      o Workaround for 9.1 or later software where the
        "ip classless" command is not available: install a
        "default network route" like this:
        "ip route 39.0.0.0 255.0.0.0 <next-hop>" along the axis
        the default route would normally take.  It appears
        an ISP can utilize the "recursive route lookups" so
        the "next-hop" may not actually need to be a directly
        connected neighbour -- the internal router can e.g.,
        point to a loopback interface on the border router.
        This can become "really uncomfortably messy" and it may
        be necessary to use a distribute-list to prevent
        the announcement of the shorter mask.
      o Workaround for 9.0 or older software: create a
        "default subnet route": "ip route 39.x.y.0 <next-hop>"
        combined with "ip default-network 39.x.y.0", otherwise
        as the 9.1 fix.
 Both of the latter solutions rely on manual configuration, and in the
 long run these will be impossible to maintain.  In some topologies
 the use of manual configuration can be a problem (e.g., if there is

Manning Informational [Page 4] RFC 1879 Class A Subnet Experiment January 1996

 more than one possible exit point from the AS to choose from).

Recommendations:

 The RFC 1797 experiment appears to have been a success. We believe it
 safe to start carving up "Class A" space, if the spaces are delegated
 according to normal IR conventions [7] and recommend the IANA
 consider this for future address delegations.

Credits:

 Thanks to all the RFC 1797 participants. Particular thanks to Paul
 Vixie, Geert Jan de Groot, and the Staff of the IETF33 Terminal room.
 Other thanks to ACES, MCI, Alternet, IIJ, UUNET-Canada, Nothwestnet,
 BBN-Planet, cisco systems, RIPE, RIPE NCC, ESnet, Xlink, SURFnet,
 STUPI, Connect-AU, INBEnet, SUNET, EUnet, InterPath, VIX.COM,
 MindSpring.  Especial thanks to Suzanne Woolf for cleanup.

References:

 [1] IANA, "Class A Subnet Experiment", RFC 1797, USC/Information
     Sciences Institute, April 1995.
 [2] Eidnes, H., and G. J. de Groot, "Classless in-addr.arpa
     delegation", Work in Progress, SINTEF RUNIT, RIPE NCC, May 1995.
 [3] Huston, G., "Observations on the use of Components of the Class A
     Address Space within the Internet", Work in Progress, AARnet, May
     1995.
 [4] Bates, T., et.al, "Representation of IP Routing Policies in a
     Routing Registry", RFC 1786, MCI, March 1995.
 [5] http://info.ra.net/div7/ra/Ops.html, November 1995.
 [6] Baker, F., Editor, "Requirements for IP Version 4 Routers", RFC
     1812, cisco systems, June 1995.
 [7] Hubbard, K., Kosters, M., Conrad, D., and D. Karrenberg,
     "Internet Registry Guidelines", Work in Progress, InterNIC,
     APNIC, RIPE, November 1995.

Manning Informational [Page 5] RFC 1879 Class A Subnet Experiment January 1996

Security Considerations

 Security issues were not considered in this experiment.

Editor's Address:

 Bill Manning
 Information Sciences Institute
 University of Southern California
 4676 Admiralty Way
 Marina del Rey, CA 90292-6695
 USA
 Phone: +1 310-822-1511 x387
 Fax:   +1 310-823-6714
 EMail: bmanning@isi.edu

Manning Informational [Page 6]

/home/gen.uk/domains/wiki.gen.uk/public_html/data/pages/rfc/rfc1879.txt · Last modified: 1996/01/05 22:46 by 127.0.0.1

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki