value currently held in accumulator,
and the result is then put back into
the accumulator. It is a... is 1
byte) could be simplified. Once the
result of the A - arguement is fonud,
then the oppisit... se 0 and
vice versa) is subtracted from the
result. (The carry is a one bit flag
and can only hol... FIRST NUMBER
ADC #SECOND NUMBER
And your desired result is in the
accumulator. As we said earlier,
out OK since counting in 1-byte produces the same result of
adding 80H + 80H as with adding 00H + 00H.
... ions are actions taken in reponse to a
particular result, actions which can result in another
state.
The state table shows the complete set of states for a
progr... rograms without this option
should ignore the <C> result in the Send-Init state and
also ignore the Rec-In
.
.pa
OK, enough: what's on the disk
The end result of all the crap in the Pup package is two
progra... the status register with the cd-bit, and if
the result is not zero, then the modem is assumed to be
onl... ified in PUP.SET should set the modem
to numeric result codes and autoanswer OFF. Pup answers the
phone by waiting for a RING result code, then issuing an ATA
command, and waiting f
1 IF IT WAS -
V. THE OVERFLOW BIT-0 IF THE LAST RESULT DID NOT OVERFLOW
*. UNUSED
B. BREAK STATUS-1 AF... ERRUPT-0 AFTER CLI 1 AFTER SEI
Z. ZERO-0 IF LAST RESULT WAS NON-ZERO 1 IF IT WAS 0
C. CARRY-0 IF THE LAST RESULT DID NOT CARRY OR A CLC AND 0 AFTER A CARRY OR SEC
mmands.
Negative numbers will not be shown in the result when XC (next page) is used with HEX.H, although ... x, binary, decimal and negative decimal. The same result would be achieved by typing "XC,E$FF69" or "XC,E6... created by RAM.SAVE or semi-disaster will surely result!
3. Press Return to load all of the special flopp
ompatible formats, all achieving the same general result, cannot be
allowed to appear.
It is proposed ... the
data length is an even multiple of 128. As a result, the Binary II
form of a file is never more than... by dividing EOF by 128 and adding one to the result
if EOF is not 0 or an exact multiple of
from the
contents of the accumulator and this
result is dicarded except for the
effects on the z... henever a zero is loaded,
stored, or gotten as a result in an
arithmatic command, such as the CMP. ... gative number is loaded,
stored, or gotten as a result in an
arithmatic command. This machine of
BLOADED FILE USE: PEEK(-21902)+PEEK
(-21901)*256 (RESULT IS IN HEX)
TO DETERMINE THE LENGTH OF THE LAST BLOADED FILE USE: PEEK(-21920)+PEEK(-21919
*256 (RESULT IS IN HEX)
TO DETERMINE THE LINE NUMBER THAT CAU