information. If the router does not cache the specified content, it
inserts its Report block into the ... wnstream" with respect to data, unless explicitly specified.
Scheme name:
A scheme name indicates a... ace on which data are expected to arrive from the specified
name prefix.
Outgoing face:
The f... or router are expected
to transmit for the specified name prefix. It is also the face on
which
of the IP DSCP at Lower Layers
5.1. Mapping Specified for IEEE 802
5.1.1. Mapping Specified for IEEE 802.1
5.1.2. Mapping Specified for IEEE 802.11
5.2. Diffserv and MPLS
5.2.1. Mapping Specified for MPLS
5.2.2. Mapping Specified for MPL
3 }
Specific conventions to be considered are specified in Section 2 of
[RFC5754].
2.2. SHAKE
Th... e the only members of the SHA3-family that
are specified for use in X.509 certificates [RFC8692] and CMS
... 2 }
Specific conventions to be considered are specified in Section 3.1 of
[RFC8702].
3. Signature Al... 0 }
Specific conventions to be considered are specified in [RFC4056].
The signature algorithm RSASSA-
519 or Ed448), the public key is in
the format specified in [RFC8032].
For cipher suites using the Ell... 46].
5.1.2. Signing
The signature algorithm specified in a group's cipher suite is the
mandatory alg... It MUST be the same as the signature algorithm specified in the
credentials in the leaves of the tree (... e signatures used in this document are encoded as specified in
[RFC8446]. In particular, ECDSA signatures
tion 4. An overview of the PCEP
extensions is specified in Section 5. A solution to address such
requirements with PCEP object extensions is specified in Section 6.
1.1. Conventions Used in This Doc... is section is built on the basis of stateful PCEs specified in
[RFC8231] and PCEP for GMPLS specified in [RFC8779].
The operation of a stateful PCE on LSPs can b
related information along with the topology
is specified in [RFC9085] for the MPLS data plane instantiatio... rtised
(Section 3.2) using the Node MSD TLV specified in [RFC8814].
* Algorithm support for SRv6 is advertised via the SR-Algorithm TLV
specified in [RFC9085].
The SRv6 information pertaining... rtised (Section 4.3) using
the Link MSD TLV specified in [RFC8814].
The SRv6 information pertaining
nnounce support for the assert packing mechanisms specified in
this document. PackedAssert messages (Sect... e message is a (non-packed) PIM Assert message as specified
in [RFC7761]. See Section 4.2. In this case,... n 4.4.
Two aggregated assert record types are specified.
The "Source Aggregated Assert Record" (see S... ing and receiving of
PackedAssert messages, as specified in the following subsections, are
logically ne
ecific requirements (e.g., uniqueness
during a specified period of time) that must be satisfied such that
... tations that simply fail to comply with the
specified requirements
A number of IETF protocol specifications under specified their
transient numeric identifiers, thus lead... r implementations.
The IPv4 Identification is specified in [RFC0791], which specifies
the interoperabi
where.
Busy hour: A one-hour period within a specified interval of time
(typically 24 hours) in wh... g: A class of routing protocols that takes
specified traffic attributes, network constraints, and poli... ticular service according to the parameters
specified in a Service Level Agreement. "Quality" is
... he details of how the network carries packets are specified in the
policies of the network administrators
The network programming paradigm for SRv6 is specified in [RFC8986].
It describes how any behavior ca... 986] is
necessary to understand the extensions specified in this document.
At a high level, the extens... pporting the
O-flag in the SRH flags, as specified in [RFC9259].
Other flags are not defined ... nt to the Router LSA of the advertising router as specified in
Section 4.4.3.9 of [RFC5340].
In cases
nsidered relying upon the discovery mechanisms
specified in [RFC2132], [RFC3646], and [RFC8106] to retriev... s
for encoding SvcParams using the wire format specified in Section 2.2
of [RFC9460]. This encoding ap... rameters are encoded following the rules
specified in Section 2.2 of [RFC9460].
- The option... ioning Mechanisms
The provisioning mechanisms specified in this document may not be
available in speci
ument. In this document, "IESG Ratification",
specified in Section 5.1, refers to a combination of Expert... are documentation code points under the IANA OUI specified
below.
1.4. CFM Code Points
IEEE Std 802... s (SAIs). An SAI is assigned by a
protocol specified in an IEEE 802 standard, for example,
[IEEE... SAI quadrant and assigned by a protocol
specified in an IEEE 802 standard, the SLAP is optional. L
(e.g., IP, MPLS, and optical) that use
an IETF-specified data plane and/or management/control plane. They... the SDPs. An IETF
Network Slice Service is specified in terms of a set of SDPs, the
associated c... ETF Network
Slices to move packets between the specified endpoints of the service
in accordance with specified characteristics.
A clear distinction should be
topology
between VPN sites.
The base model specified in Section 5 can be extended to include
techno... data and state, can use the
subscription model specified in [RFC8641] to subscribe to the
specific netw... interface metrics), various notifications can be specified to obtain
more complete data. A periodic notification [RFC8641] can be
specified to obtain real-time performance data. For device
in
automated certification path validation, as specified in Section 6 of
[RFC5280].
Automated certi... olicy. The
algorithm for this verification is specified in [RFC5280].
The automated processing provid... OT be included.
Image format requirements are specified in Section 7, and audio
format requirements are specified in Section 8.
When language is specified, the