tocol data in the
frame appears immediately after the destination and source MAC
addresses. ... re 8-bit protocol identifiers that occur in pairs after a
field that gives the frame length. Such ...
where the length field appears immediately after the destination
and source MAC addresses. ... erType. Putting the EtherType as the zz-zz field after an all-
zeros OUI (00-00-00) does this. It lo
s and adapt to network
events, such as routing after failure.
Another important objective of Inter... escribed level
of QoS for existing services after a given number of failures
occur within the... aintaining the required QoS for existing services after recovery.
Survivability is an issue of great c... d node outages. Rerouting at the IP layer occurs after a period of
routing convergence, which may req
fic analysis, to user privacy considerations.
After an introduction that covered the goals of the wor... improve user privacy,
such as discarding data after a short period of time, masking aspects
of dat... k
flows or monitoring or monetizing usage.
After an introduction that covered the goals of the wor... ort
the deployment of developed solutions.
After new technologies and related standards are develo
ght trigger a query retry and a larger timeout
after which the server is considered unresponsive. Sec... for an RRset but is unable to do so,
possibly after trying multiple authoritative name servers. DNSS... send any corresponding
outgoing queries until after the cache entries expire.
Implementation deta... ailure
might be set to 5 seconds and increased after each retry that results
in another resolution
1] to allow the PCE to initiate LSP establishment after the
path is computed. An LSP Initiate Request... N-CAPABILITY (29).
5.2. LSP Synchronization
After the session between the PCC and a stateful PCE is
payload if
there is no upper-layer protocol after the transport layer.
* For a TCP segment [RF... payload if
there is no upper-layer protocol after the transport layer.
* For an IPv6 packet [R
Response Certificate
During the TLS handshake after the TLS ClientHello, the server will
respond w... censorship, a punitive form of censorship whereby after a censor
disrupts a forbidden connection, the ... s precisely what the
censor continues to block after censorship is initially triggered.
There are t... address [Halley-2008]. Cache poisoning occurs after the requested
site's name servers resolve the
rability. Optional path segments MAY
be added after the registered application name (i.e., after "/.well-
known/cmp") to provide distinction. The path s... xx response without the Observe Option [RFC7641], after some time,
a client MAY try to register again
ature tuples, where all messages are distinct,
after interacting with the server (signer) as a client ... arns nothing about the client input and output
after the protocol execution. However, additional assu
ing zone to
resolve the name server addresses (after following the referral to
the sibling zone). ... e glue records in the
additional section. If, after adding glue for all in-domain name
servers, th
Group Address
and Source Address pair.
After parsing the PIM common header, individual records... Group Address
and Source Address pair.
After parsing the PIM common header, individual records... ng as the RP and DR have the feature enabled.
After receiving a PIM Packed Null-Register message, the... particularly useful in the transitional
period after the network manager disables it.
7. Fragmentati
d to be performed at
the Message Originator after a Feedback Message is received?
This experime... must decide for themselves
what action to take after receiving a Feedback Message.
The Message Ori