Differences

This shows you the differences between two versions of the page.

--- computerfaq:vigor_28xx_cannot_map_port_5060_due_to_message_udp_port_5060_is_occupied_by_router_voip_service_please_disable_voip_if_you_would_like_to_open_port_5060_to_your_lan_device [2021/08/25 09:43] – created genadmin
+++ computerfaq:vigor_28xx_cannot_map_port_5060_due_to_message_udp_port_5060_is_occupied_by_router_voip_service_please_disable_voip_if_you_would_like_to_open_port_5060_to_your_lan_device [2021/08/25 10:30] (current) – removed genadmin
@@ Line 1: / Line 1: @@
-This is an issue with the GUI and can be resolved using telnet
-First get an index for IP Aliases (if used)
-<code>router> ip aux ?
-%% ip aux add [IP] [wanX]
-%% ip aux remove [Index] [wanX]
-%%     Where IP = Auxiliary WAN IP Address.
-%%           Index = The Index number of table.
-%%           wanX = add/remove an address for WANX.
-Now auxiliary WAN1 IP Address table:
-Index no.	Status	IP address
-----------------------------------------------------
-		Enable	1.2.3.4
-		Enable	1.2.4.5
-</code>
-Now make the mapping from the command line using
-<code>srv nat portmap add <idx> <serv name> <proto> <pub port> <src ip type> <src ip idx> <pri ip> <pri port> <wan1/wan2> <Alias IP></code>
-So for example:
-<code>router> srv nat portmap add 15 sip udp 5060 0 0 192.168.1.10 5060 wan1 2</code>
-That being
-  - profile 15
-  - name SIP
-  - public port protocol UDP
-  - public port 5060
-  - any source ip
-  - any source ip type
-  - private IP 192.168.1.10
-  - private port 5060
-  - wan interface wan 1
-  - IP Alias index 2